converting a skoped mesh

[the_ultimate_evil]

does anyone have any tips or info on converting a skoped :ff: mesh so that it works in :ffvstr:. i've a few meshs i skoped using the orginal CT, yet no matter how many times i try and convert them they still crash CT2

i'm also getting this is itry and work with 2 converted meshs

"nif versions differ

current file version 4.00.1
clipboard data version 10.1.00

the result could be unpredictable"

[Revenant]

Hmm.. I have had that last message more times than i care to remember.  I think FF1 meshes are version 4.0 something.  If you try to copy parts from meshes that are different versions you get that message and it never actually works.  I then accept the fact that the mesh will only be usable in FFvs3R...

...and I'll convert the 4.0 mesh to FFvs3R, and the parts work fine after conversion.

As for the first problem.. i haven't had any meshes refuse to work after skoping and conversion.  Maybe try converting the component parts first?

[the_ultimate_evil]

whats werid is i got the message when i was working with two message that were already converted, yet worked fine when not converted

[Symon]

"current file version 4.0.0.2"

This is an FF mesh.

"clipboard data version 10.1.0.0"

This is an FF3R mesh.

One explanation is that your conversion did NOT work. It can be tricky to do sometimes.

[the_ultimate_evil]

this is werid twice this has happened.

i convert the mesh and kf's and then start skoping, i check it in CT2 the mesh shows but no kf's

[Tomato]

this is werid twice this has happened.

i convert the mesh and kf's and then start skoping, i check it in CT2 the mesh shows but no kf's

You sure it converted the keyframes? Sometimes it won't convert both even though it says it does.

[the_ultimate_evil]

yeah it was a skope of rens hourman, i converted the kf's and nothing so i thought i'd try and swap them with the kfs from the non skoped hourman still nothing, i put in rens superman and blam they work